Page 1 of 1

Y Axis Configuration- Flashforge Creative Pro

Posted: Thu Sep 11, 2014 11:30 am
by felisrufa
Hello.

New machine, new to 3d printing. How do I configure the baseline Y Axis in Simplify 3D for the printer? Do I need to do this on the printer directly? My print jobs are way off the plate right now.. In the model it shows them being in the middle.

Thank you

Eric

Re: Y Axis Configuration- Flashforge Creative Pro

Posted: Fri Sep 12, 2014 5:00 pm
by KeyboardWarrior
You can use the Gcode offsets in the G-code tab. For instance, my prints were always coming up 5 mm to the right of my bed, so I did -5mm on the X-axis and now my prints are centered.