mattypanda
Posts: 1
Joined: Mon Feb 17, 2020 7:46 pm

Stop the CR-10S Pro from puncturing print when it auto-levels

Fri Feb 28, 2020 6:29 pm

Howdy folks.

I have figured out how to split up prints in Simplify3D so that I can print one model with multiple colors by switching out the filament and firing up the printer at a height at which it left off.

The problem is the CR-10S Pro likes to auto level the entire bed before it starts printing (all 16 points) which will inevitably push the 190ºC extruder into my print multiple times depending on the size.

Any recommendations to what I can alter/delete in the scripts tab?

S3D-Chris
Posts: 215
Joined: Wed Jun 20, 2018 12:52 pm

Re: Stop the CR-10S Pro from puncturing print when it auto-levels

Tue Mar 03, 2020 10:00 am

You can use multiple processes but it may be easier to use a post-processing script for a filament swap. Use the command {REPLACE "; layer 153\n" "M600\n; layer 153\n"} and replace the "layer 153" with the layer that matches your model.

Return to “General Discussion and Tips”