Simplify3D User Forum

Hey everyone!

I'm wondering if it is possible to have a higher infill percentage in different parts of the print?

Example:

Layer 1-40=20%
41-50=90%
51-70=20%
71-80=90%
81-99=20%
I have a Yoshi model that I need to be stronger where the arms and legs are connected to the body, but it's a waste of plastic to print it 90% all over.
Any Ideas?

SD

Des that s possible.
Take a look at

https://youtu.be/OcddlK36OVs

Regards

Dead easy.....have a read of this article:
https://www.simplify3d.com/support/arti ... f-a-model/

Thanks alot!

I haven’t seen these articles! Alot of good reading.

SD

I'm off to self-quarantine for at least 14 days!