LulzBot Mini 1 with 0.25 micro nozzle.
Posted: Mon Jun 29, 2020 4:16 pm
I am able to connect by changing the communication rate to 25,000.
How do I set up the software for the micro 0.25 nozzle?
Also after I put a model on the plate, how do I increase the copies to 8?
Lastly where is the best place to learn about this software?
Thanks so much
Jay Beckham
How do I set up the software for the micro 0.25 nozzle?
Also after I put a model on the plate, how do I increase the copies to 8?
Lastly where is the best place to learn about this software?
Thanks so much
Jay Beckham