S3D does work for the Creator 3.
I havent had many issues. I did run into an issue with S3D that the left and right nozzle alignment was incorrect, but after adjusting the tool 1 on the x axis by -1.78 mm, i did have this resolved.
Also, an additional issue i am noticing is that if the print is paused, the print is no longer alligned. This will be off by 0.85 mm. I am still trying to figure this out.
In S3D, you can not do mirror mode or duplicate mode right away.
There is, on the other hand, a profile available that allows you do do so for Flashforge Creator 3.
It is available here somewhere, but will also add it to this topic. It only does duplicate. I hope im adding the proper file
- FlashForge Creator 3 Duplication Print Version 2.fff
- (53.13 KiB) Downloaded 114 times