UnRealWoody
Posts: 7
Joined: Mon Nov 11, 2019 3:25 pm

Flashforge Creator 3 unalligned on x-axis after pausing print

Sun Nov 01, 2020 2:16 pm

Has anybody figured out yet what to adjust to avoid the print not being alligned after the print got paused?
I am not sure what to adjust for this.

BTW: This offset is 0.85 mm. This offset only happens when G code was made with S3D, this does not happen if using other slicers like Flashprint.

Return to “General Discussion and Tips”