Please see attached .factory file - I'm printing a cover for a filtering module & there's no issues so far....
However, I've sometimes wondered why I'm getting a bridging layer in situations like this & I figured, it's time to ask?
In this model, even though the flange is fully supported (normal support & 2 layers dense support at 50%). S3D is still putting a bridge layer in & I seem to get that quite often... But I don't think bridging is required here...?
I know, I can switch bridging off, by increasing the value for the threshold to "99999" - but the current value (50 sq mm) should be enough to prevent it from occuring in this model. (By the way, increasing the value to 500 or 1000 sqmm still results in the bridge layer being added - so the threshold value doesn't appear to be driving the decision?).
I've also tried setting the dense support to 100% & the separation layers to 0 - but the bridge layer is still being inserted.
Why is that, please?