Page 1 of 1

Comparisons to other slicers

Posted: Fri May 10, 2013 9:53 pm
by brucethehoon
I'm about ready to pull the trigger on the purchase based on the support management alone, but I would really like to see some sample prints that were sliced in Simplify3D. Is there a good user submitted gallery I can look at?

thanks!

Re: Comparisons to other slicers

Posted: Sat May 11, 2013 5:36 pm
by mathisyourfriend
Read the MakerGear google group for feedback from users. I'm more than pleased with it.