Posts: 1
Joined: Sat Jan 02, 2021 5:06 pm

Stringing - The Everlasting issue

Sat Jan 02, 2021 5:24 pm

Hi guys,

So new to the forum, and have been messing around with my E5+ for some time now. :)

Lately I have been trying to get this model to look decent without stringing, but I cant figure out how to avoid the stringing in the corners :(

Have attached a few photos and my FFF profile, that I have been using for the model.

Any tips/hints/advice will be greatly appreciated :)
Shoerack v1.fff
FFF Profile
(12.07 KiB) Downloaded 4 times
Pic 1
Pic 2

Posts: 906
Joined: Wed Jun 20, 2018 12:45 pm

Re: Stringing - The Everlasting issue

Mon Jan 04, 2021 11:32 am

Stringing is easily managed using the retraction settings in Simplify3D. What you're seeing is that Simplify3D doesn't detect a retraction is needed when crossing over what is "Infill". To force retractions in those areas, turn off "Only retract when crossing open spaces" setting in the advanced tab of your FFF settings.
"A bird does not sing because it has an answer. It sings because it has a song."

Return to “General Discussion and Tips”