Posts: 1
Joined: Sun Jan 31, 2021 2:12 pm

STL file cannot sliced correctly

Sun Jan 31, 2021 2:20 pm

Hi everyone

I'm using S3D already for years by now. Every once in a while you get problems to achieve correct GCodes
I’m using one of my selfmade printers working with Duet 2 Wifi.

The attached STL file I cannot slice so that i get it run.
The original File comes from a guy who sells 3D-planes to print.
He says that only Cura can slice this file to get the correct GCode.

Do you have an idea where the problem ist o be located? Can you get it sliced an get a GCode?

I tried now for over 2 days but no result.

I would appriciate if you can help me out.

And great thank you for your efforts.

(1.4 MiB) Downloaded 14 times
(223.67 KiB) Downloaded 13 times

Posts: 18
Joined: Thu Jul 30, 2020 11:09 am

Re: STL file cannot sliced correctly

Wed Feb 10, 2021 10:49 am

This model appears to be a single, open surface, rather than a valid, manifold STL.

The following links explain these issues in more detail and provide specific suggestions for how to fix them: ... sh-errors/

The main issue is that I believe that these models were created this way on purpose, to trick the slicer into slicing them a certain way, which will not work on Simplify3D without extensive tweaks and workarounds.

Return to “General Discussion and Tips”