Posts: 1
Joined: Wed Feb 10, 2021 11:44 pm

Lift Z on Travel

Thu Feb 11, 2021 3:13 pm

Hello all,

Is there an option that I'm just not seeing for slightly lifting the Z on travel and then lowering it back down after the travel is complete?

Posts: 912
Joined: Wed Jun 20, 2018 12:45 pm

Re: Lift Z on Travel

Tue Feb 23, 2021 10:34 am

I believe you’re looking for the setting listed below.

Extruder tab > Extruder controller > retraction vertical lift

More details on the extruder tab’s settings can be found here: viewtopic.php?f=8&t=1980#p7648
"A bird does not sing because it has an answer. It sings because it has a song."

Return to “General Discussion and Tips”