Trad
Posts: 1
Joined: Sat Feb 13, 2021 4:44 am

Have a double configuration for infil

Sat Feb 13, 2021 4:53 am

Hello, sorry for the question, I want understand if is possile with simplify 3d to have a double configuration for the infill. I want use it for 2 cm hight and then not.

I'm printing a candelier , I want that in the base where the lamp is attached to have the infill 15%

Instead on the arm of the candelier to have vase mode or a simply 3 shell, without infill setting.

The reason of this choise is to print it with transparnt material, and if I print all with infill the arms have not a good effect when the light pass inside the arms...

https://www.thingiverse.com/thing:4624250

Some one can give me an advice to resolve this problem?

S3D-Jake
Posts: 912
Joined: Wed Jun 20, 2018 12:45 pm

Re: Have a double configuration for infil

Tue Feb 23, 2021 10:31 am

Have you seen this guide? https://www.simplify3d.com/support/arti ... f-a-model/

Setting up multiple processes should be all you need in order to do what you’re suggesting.
"A bird does not sing because it has an answer. It sings because it has a song."

Return to “General Discussion and Tips”