swimmerhair
Posts: 3
Joined: Tue Sep 22, 2020 7:47 pm

BCN3D Sigma Printer gaps in bottom layers?

Wed Mar 24, 2021 12:31 pm

Hi Everyone,

I've been trying to debug this issue for a while now and cannot seem to figure it out. My first layer has gaps, which leads to poor structural integrity and adhesion between the first and second layers. See picture https://imgur.com/rXC5NDy. I have tried everything it seems to try to close those gaps but cannot seem to figure it out. Does anyone have any tips? See also my attached settings file.
Attachments
BCN3D - .007 Layer.fff
(13.02 KiB) Downloaded 8 times

Return to “General Discussion and Tips”