tenaja
Posts: 142
Joined: Wed Dec 17, 2014 5:16 pm

Report layer change to Octoprint?

Thu Mar 25, 2021 9:00 am

Is there a command I can put in the Layer Change Script to tell Octoprint the Z location? I would like to be able to see where it is on the Z height, in Octoprint, without printing with Octoprint.

For those asking "why not print from Octopring?", my 3d printer cannot print well using it--the printer pauses frequently, creating blobs. It's just a poorly implemented, closed-source firmware; it's a 32-bit processor, and it cannot even update the touchscreen without creating blobs unless I press it during a long straight line. But I'd still like to be able to check up on it beyond just with the camera. (It will be replaced, eventually...)

So, I thought maybe I can insert a command at Layer Change to give me a Z height. Does anybody know if there is something for this?

Return to “General Discussion and Tips”