I received my D12 500 (dual) today and was a bit disappointed that the printer is configured in Cura 4.6 (old version) and not 4.8. I would like to create a generic printer in S3D and copy the profile over from Cura. Start script and ending script are easy but I'm a bit stumped on the tool change script. In Cura each extruder has its own start and end code but in S3D there is only one place to add the code.
Any suggestions on how/where I copy each of the extruder start and end codes into S3D (T0 and T1)
Am I looking in the right place