Posts: 1
Joined: Fri Apr 09, 2021 10:37 am

Floating supports

Fri Apr 09, 2021 10:41 am

I'm trying to print the Mummy Cat from ... oween-cats at 150% scale. The cat has a bandage hanging from its nose, and the end of the bandage isn't attached to any other part of the model, so it definitely needs good support. But try as I might, the very first layer of that bandage is still dangling in the air, as can be seen in the screenshot I attached. Is there any way to "broaden" the auto-generated supports?
Screenshot 2021-04-09 163924.jpg

Posts: 927
Joined: Wed Jun 20, 2018 12:45 pm

Re: Floating supports

Mon Apr 12, 2021 12:52 pm

You can broaden the autogenerated supports by making use of the "extra inflation distance" setting. This will make the generated supports larger in the X and Y plane.

for more on the settings found in the supports tab see this post: viewtopic.php?f=8&t=2135
"A bird does not sing because it has an answer. It sings because it has a song."

Posts: 85
Joined: Wed Oct 01, 2014 2:12 am

Re: Floating supports

Sat Apr 24, 2021 5:27 pm

It's also good to run your supports in 2 angles like 90 and 45 degree.

Return to “General Discussion and Tips”