Page 1 of 1

Enable fan if print time is below t seconds

Posted: Fri Apr 30, 2021 5:51 am
by aaronn7909
is there a away to Enable fan if print time is below t seconds

Re: Enable fan if print time is below t seconds

Posted: Wed May 05, 2021 10:44 am
by S3D-Rick
Yes, in the Cooling tab, "Increase fan speed for layers below __ sec" does this.

Re: Enable fan if print time is below t seconds

Posted: Wed May 05, 2021 8:05 pm
by aaronn7909
If I turn on cooling and set a layer height to 0 and just the seconds it will work ill give it a go the next time im playing with the 3d printer thanks