Page 1 of 1

CR-10 V3 Retraction Settings

Posted: Sat May 29, 2021 6:13 pm
by savall21
I have not been able to find a CR-10 V3 profile from Simplify 3D. I found one on Thingiverse and started with it. I modified the retraction setting to have:
retract_settings.png
Retraction Distance .6 mm
Retraction Speed 2800

I attached a screenshot of the setting. I'm still getting some stringing. The prints look good though. I'm attaching a High quality and Medium quality Benchy photo. I"m just looking for some tips on how to remove the stringing.

The full profile is attached.