Dual Color Printing Issues - Creatbot F430
Posted: Wed Jun 16, 2021 6:18 am
Hello,
I am facing an issue with my Creatbot F430.
The nozzle which isn't the printing one is always extruding a little bit of filament.
That causes the printed part to be extremely stringy.
I activated the "Prime Pillar" and the "Use Ooze Shield" functions.
But it didn't fix my problem.
Any ideas?
Best regards.
Bubble
I am facing an issue with my Creatbot F430.
The nozzle which isn't the printing one is always extruding a little bit of filament.
That causes the printed part to be extremely stringy.
I activated the "Prime Pillar" and the "Use Ooze Shield" functions.
But it didn't fix my problem.
Any ideas?
Best regards.
Bubble