How to edit the eeprom?
Posted: Wed Jun 23, 2021 2:58 pm
by BD22
If I want to change an eeprom setting, like the steps per feed, how can I do that with Simplify3D?
Re: How to edit the eeprom?
Posted: Wed Jun 23, 2021 6:03 pm
by TheBum
Look at the g-code definitions for the firmware your printer runs. This is my go-to reference for such things:
https://reprap.org/wiki/G-code
That said, it's a much better idea to make the change in your printer's configuration files.