yaxetimo
Posts: 1
Joined: Fri Jul 30, 2021 4:32 am

extruder - Y direction only

Hello,
After first layer, extruder moves off from first layer , and just start doing its job.
Eventually it turns out good. but Is there any tweak i can fix this issue?
It always move in Y direction.
S3D-Jake
Posts: 1052
Joined: Wed Jun 20, 2018 12:45 pm

Re: extruder - Y direction only

Can you attach your factory file?

Also, can you clarify what you mean by "extruder moves off from first layer?" as what is happening is important to understanding how to resolve the issue.
"A bird does not sing because it has an answer. It sings because it has a song."

Return to “General Discussion and Tips”