Page 1 of 1

extruder - Y direction only

Posted: Fri Jul 30, 2021 5:01 am
by yaxetimo
After first layer, extruder moves off from first layer , and just start doing its job.
Eventually it turns out good. but Is there any tweak i can fix this issue?
It always move in Y direction.

Re: extruder - Y direction only

Posted: Mon Aug 02, 2021 2:18 pm
by S3D-Jake
Can you attach your factory file?

Also, can you clarify what you mean by "extruder moves off from first layer?" as what is happening is important to understanding how to resolve the issue.