JafferStroks
Posts: 1
Joined: Mon Aug 23, 2021 3:40 am

Changing a layer flow rate in a script??

There is one feature that I really like in CURA where you can increase the flow rate on the first layer to get a better "smoosh" and a smoother surface. S3D only allows you to change the line width, that REALLY isn't the same thing. There are a variety of hidden scripting changes that you can make at various points in an S3D print.

Has anyone found a way to increase the first layer flow rate? Or, perhaps even better, arbitrarily change the flow rate at any layer?

be well,
S3D-Jake
Posts: 1052
Joined: Wed Jun 20, 2018 12:45 pm

Re: Changing a layer flow rate in a script??

Have you tried adjusting your eSteps using the post processing command "REPLACE"?

viewtopic.php?t=1959
"A bird does not sing because it has an answer. It sings because it has a song."

Return to “General Discussion and Tips”