dnear1
Posts: 3
Joined: Tue Apr 14, 2020 10:30 am

Setting up TPU print with PETG supports

Fri Sep 10, 2021 8:12 pm

I'm doing a rather large TPU test print, which will eventually have PETG parts mixed in with it.
I'm using a Modix dual extruder printer and have TPU in one and PETG in the second extruder, and haven't figured out how I can set it up so each extruder runs at a different print speed.. IE the TPU at 20mm/S and the PETG at 45mm/s so the prints don't take 3x as long as they should.
Other than setting the support speed to 200% and the main speed at 20mm/s, is there a better way to configure it?

Return to “General Discussion and Tips”