Make permanent firmware changes for Makerbot Replicator 2?
Posted: Thu Sep 16, 2021 4:28 am
Hi! I got the Simplify3d software up and running with nice results, when connected via USB. I have a Bondtech extruder so I have to change the A-axis e-steps and that works when using USB. But when I print via SD-card the printer uses the old settings in the firmware. Is there a way to make firmware changes permanent? I can't find a firmware upload function in Simplify3D - is there an other way doing it?
Best Regards / Jimmy Alenius
Best Regards / Jimmy Alenius