SHoutzager
Posts: 119
Joined: Sun Jan 03, 2016 4:02 pm

Bumps on side of prints

Thu Sep 30, 2021 4:45 pm

Everything was printing smoothly in previous prints then all of the sudden it kinda looks like over extrusion. Multiplier in S3D is set to 1. Any ideas?


https://www.dropbox.com/s/yml33tmqng6tk ... .jpeg?dl=0


SHoutzager
Posts: 119
Joined: Sun Jan 03, 2016 4:02 pm

Re: Bumps on side of prints

Fri Oct 01, 2021 10:20 am

I adjusted the flow rate to 90% and set the nozzle 5 degrees lower and it looks great now.

Return to “General Discussion and Tips”