Simplify3D User Forum

Hi All
I used ver.2.2 S3D but I have problem about the support...when actived support or manuel define all ok but prepare to print click give error....could you have any idea ? BTW I tried reset my all setting but no any change..


my system XP an Turkish error mean " 0x...... not reading"


my simple object



my support settings

ta1dr wrote:Hi All
I used ver.2.2 S3D but I have problem about the support...when actived support or manuel define all ok but prepare to print click give error....could you have any idea ? BTW I tried reset my all setting but no any change..


my system XP an Turkish error mean " 0x...... not reading"


my simple object



my support settings

This could be due to graphics drivers not being able to load the print previewer. Have you tried updating your Nvidia/ATI/etc Graphics drivers?