Skimmy wrote:Is there a way to do a z-offset between two toolheads with this?
Tool 1 is 2mm higher over the printbed than Tool 0. In the settings, I can only put in X & Y offsets, but no Z-offset
You could try a relative Z move, but the way the dual color printing is structured (color 1, color 2, color 2, color 1, etc..) will cause issues with that, because any time the second layer gets started it will move the head in exact coordinates rather than relative.
Skimmy wrote:And why does {IF OLDTOOL=0} or similar doesnt work in the endscript, while it does in the toolchange-script?
This would be because the if oldtool and if newtool options are only given in the Toolchange script.