Re: Tip of the Day 8- Scripts tab, G-Code
Posted: Sat Jul 23, 2016 12:16 pm
Did you ever get an answer to this?JATMN wrote:I want to move that to the top though and manipulate it.
Simplifying the 3D Experience!
https://forum.simplify3d.com/
Did you ever get an answer to this?JATMN wrote:I want to move that to the top though and manipulate it.
Thanks for setting up some scrips for everyone on thingiverse, I've been printing with the script for some time now and it makes quite a difference for oozing and what not. As a side note I've found that you can get away with a "cool down" temperature between 175-185 for PLA which saves some time on the print if you have a lot of tool changes.arnljot wrote:I've taken the liberty to create a Wanhao compatible script and post it over at thingiverse. You can see it hereblaknite7 wrote: G1 X0 Y40 F4000 ; move to wait for temperatures
{IF NEWTOOL=0}M104 S165 T1; set T1, inactive extruder to 165 C
{IF NEWTOOL=0}M109 S205 T0; Set T0, new active extruder to T0 Temperature and wait for it to reach temperature before proceeding.
{IF NEWTOOL=1}M104 S165 T0; Cool T0 to 165
{IF NEWTOOL=1}M109 S205 T1; set T1, Heat T1 to T1 Temperature
Yes, I have both of these selected and for some reason it still leaves little tip marks on each separate horizontal layer for some reason. It's driving me nuts.DarthRevan wrote:Wiping + Retract during wipe movement is what you're looking for. (Wipe can be turned on in the extruder tab, and retract during wipe is in the advanced tab)
Have you tried lowering your print temperature slightly?InoTek3D wrote:Yes, I have both of these selected and for some reason it still leaves little tip marks on each separate horizontal layer for some reason. It's driving me nuts.DarthRevan wrote:Wiping + Retract during wipe movement is what you're looking for. (Wipe can be turned on in the extruder tab, and retract during wipe is in the advanced tab)