It seems like certain horizontal walls are underextruded in certain areas of a print. But always in the same spot, even if I change the location on the build plate. What would cause this? Using 2.2.2
I would say it is a filament problem, but why would it be repeatable in the same areas? I got rid of it by lowering the filament diameter down to 1.61. But the smallest part of the filament is never less than 1.68. This obviously results in overextrusions in areas that were previously ok.
Also having trouble understanding the new vertical wall fill feature. If I want the software to fill the walls always what are the settings? It seems no matter what I do the only way to be sure a vertical wall gets filled is to make sure the thickness is an even multiple of my extrusion width.