I've been playing with some of the Creator profile settings for my stock M2 using PLA. I'm NOT an expert, I just wanted to share what's been working for me with others. It would be great to have a thread discussing what works and what doesn't.
What's different about this profile:
First layer is %120 thicker, this helps adhesion and leveling.
I run 185 for PLA.
Firmware supports G2/G3 is checked, because it does.
Custom start and end code by Ketil does a nice extrude and wipe in the beginning and a cooling routine at the end, I shortened the cooling passes and kept the fans running.
Active cooling always on and set to 65% (which is around 12 volts to the big fan)
Bridge speed multipier is set to 160%
Currently I'm getting great prints. The people behind Creator have a great product and are very responsive to feedback.
*****Please see the latest post for my most recent profile******
- (1.36 KiB) Downloaded 302 times
Last edited by tomlombardi
on Fri Apr 19, 2013 6:43 pm, edited 1 time in total.