Could Creator support SLA-type 3D Printers?
Posted: Fri Sep 06, 2013 4:22 am
Hello,
I am using an SLA-type 3D Printer. The software it provides is very primitive without support generation. The good thing is it accepts slice images like PNG.
Could Creator export slice to bitmap outputs, instead of G-Code?
Best regards,
Paul
I am using an SLA-type 3D Printer. The software it provides is very primitive without support generation. The good thing is it accepts slice images like PNG.
Could Creator export slice to bitmap outputs, instead of G-Code?
Best regards,
Paul