Andy wrote:logic1208 wrote:@Andy
Heres the 1.10 V2 Firmware!
How do you want to downgrade?
Thanks Logic, i don't know how.
I will tri to give her a higher Number........ Lets see whats happend.
@miksane at my firmware 1.12A it works but the counter goes down, even if i take material lenght 0.001
Maybee some one have a tip to fix this Problem?
This isn't a firmware issue. The counter will always go down. There is an encoder on the idler wheel of the extruder. It uses this to ensure that filament isn't jammed and to count how much filament is used. This way, it doesn't subtract the entire print job if you stop it in the middle.
The material length amount in the header is ONLY used to determine if it should START the print job. If that number exceeds what it thinks the amount left in the cartridge, then it wont allow the job to start.
The GOOD NEWS is that it apparently has to exceed the remainder by a certain amount. I've been printing on empty cartridges for a very long time now and it still allows them to start (and finish). To date, it has never stopped a job in the middle based on what it thinks is left in the cartridge.