Hey
Just bought yout software.
I have 3 problems with it.
1. Why can't I set layer height of ex. 0,3125mm ? Only 0,31. Don't like this rounding "error" as I have a 8mm leadscrew, and per http://calculator.josefprusa.cz/#layerheight 0.31mm is no go, but 0.3125 will get "clean" steps. The same with 0.125mm for my fine setting. Please fix that, thanks.
2. Your support told me I could run your software on my Raspberry Pi, but as per this post, it don't look like it. http://forum.simplify3d.com/viewtopic.p ... erry#p1359
3. When I preview a file in gcode viewer and play with the sliders. If it's not on layer but line setting and i switch to layer, the layer view does not start at layer start. Only way to fix it is to close creator and choose layer setting before play with sliders.
Other than that, it's nice...
Thanks