qarbiq wrote:Hi everyone, i own a CubePro and i am not happy with its software , it gives me prints that i am not happy my very cheap ROBO3D gives way much better prints than my CubePro by a simple Slic3R, so i am wondering if you are happy with Simplify3D for your Cubepro if you own one. By switching to this will it solve my problems ? For instance, i get a very bad prints in the 1st layers and changing setting dosnt help at all. I saw some people are using Simplify3D can anyone help ?
Simplify is a great piece of software. When used with your ROBO3D you will see what it is truly capable of! It will make your CubePro a much better printer, but that piece of hardware is pretty horrible--i am stuck with one myself at my office.
Simplify is well worth the investment, but it isn't perfect with the CubePro. It will still require quite a bit of tweaking and a whole lot of cursing. There are several profiles in these forums for use with the cubepro and all will make a vast improvement in its capability. Since you're stuck with the CP, you might as well make it usable. It wont solve ALL your problems, but it will turn a huge turd of a printer into something moderately useful.