rapreper
Posts: 1
Joined: Tue Sep 24, 2013 5:37 am

About internal dimensions

Tue Sep 24, 2013 5:44 am

I tried all slicers and found that internal dimentions are always smaller than they must be.
I print with ABS. I use for test cal.stl from Nophead's repo https://github.com/nophead/Mendel90/tre ... ls/printed
I attached it below. Creator 1.1.4 did not pass the test - nuts did not fit.
Are there any good news for this?
Attachments
cal.stl
(151.27 KiB) Downloaded 97 times

Return to “General Discussion and Tips”