Hi, I have just acquired Simplify3D prior to getting a new printer from BigBox-3D, as it is recommended by them, and I am currently adapting it to use with my Velleman K8200. This is a very steep learning curve as I expect good quality prints without too much, if any, re-tweaking between them. So far I am not getting the results that I want, primarily because of the apparent lack of a good descriptive manual, or am I missing something? Suck-it-and-see is entertaining, but not productive, and having the time to search through this forum for answers is even less so. I have too many issues to list but I'll provide a link to the BigBox-3D forum to pick up where I left off if anyone is interested in providing answers.http://forum.bigbox-3d.com/index.php?th ... fy-3d.404/
I am not writing off the product at the moment but I want to be assured that some development is being done that addresses the common issues that have appeared before on this forum. There are some really simple changes/improvements that will enhance the product. I do use freeware such as Repetier Host with Cura and Slic3r and I do contribute for developers to maintain the products. My GBP100 for Simplify3D I consider as an up-front support payment and I look forward to development.