saramos
Posts: 12
Joined: Wed Nov 18, 2015 11:04 am

Different hotends on a dual setup?

Mon Nov 30, 2015 5:38 pm

I have a Taz 5 with a single Hexagon 3mm hotend. I picked up a Hexagon 1.75 hotend with the intent of doing a conversion. But am now wondering if I could use both in a dual extruder setup with the S3D software, or if they have to be the same?

Scott

JoeJ
Posts: 1436
Joined: Sun Feb 16, 2014 10:52 am

Re: Different hotends on a dual setup?

Tue Dec 01, 2015 5:17 am

Yup, you can since they allow you to set a separate extrusion amount for each extruder. Read this: viewtopic.php?f=8&t=3718#p16283

CompoundCarl
Posts: 2005
Joined: Wed Aug 05, 2015 7:23 am

Re: Different hotends on a dual setup?

Wed Dec 09, 2015 7:17 am

I've use the method above and it works, although, you might want to get everything using the same filament size so you don't have to constantly keep both types in stock ;)

Return to “General Discussion and Tips”