In overall the printing quality is quite good the only thing I've been trying to improve is the following.
In the top layers where it has to do solid infill there are same marks where the filling gets together.
So half of it is done and the other half afterwards, in the part where the two infill sections meet.
That diagonal mark wasn't made by the nozzle dragging it was made by the two infill sections meeting together.
I have tried to reduce infill overlap (despite I think it refers to the outlines) but didn't improved.
Reducing extrusion ratio isn't much of a choice because if I do tht there will start to have gaps where the infill meets the
So my question is, is there any param that can be used to try and improve this?