erniehatt wrote:I this is a new setup using A wade type extruder and an E3D lite hotend. also the extruder is chopping chunks out of the filament every now and then
This is supposed to be solid, and it is not round as it should be.
At first glance, it looks like you're under-extruding.
If you're pushing the speed, slow it down and take it easy. Increase your extrusion multiplier and see what happens. the infill doesn't appear to be 100%. If it is set at 100%, then it is probably your extrusion multiplier set too low--(or extrusion width set too high, or filament diameter set too high, etc)