so, been chasing an issue here for a little while as ive been dialing in my new lulzbot mini. it as determined a week or so back that my ABS had become contaminated and thats why my prints look like crap. dried it out, did some testing tonight...and the Simplify3D results....are pretty awful.
printed this test cube, that i made in fusion360 so i know its 20x20x10, and im not even going to bother with listing the measurements because at this point they are irrelevant.
heres the factory file. hopefully someone can get me going in the right direction here.
.50mm nozzle
Auto Extrusion width
.20 layer height
100 percent infill
black ABS @240, bed @ 100
Simplify3D
CURA