ARTISAN
Posts: 13
Joined: Wed Mar 30, 2016 8:17 pm

"holes" on Z axis -sketchup

Wed Apr 06, 2016 2:06 pm

no mater what i do i SKP..
tryed it all(i think)....groping componenting exploding ...
meshes that "overlap" on the Z exis disappear..
insted ..it makes a "hole" and then start building on the hole (Z axis)..
making the concting very brittle,,
what i can do so the printer will print solid top layer and then continue with the print without the "hole"

what im missing over here?

using:
FFCP
Attachments
12970367_1063620570363797_1970807788_o.jpg

User avatar
dkightley
Posts: 2339
Joined: Tue Mar 10, 2015 4:09 pm

Re: "holes" on Z axis -sketchup

Wed Apr 06, 2016 2:48 pm

Are you suffering from the issue I explained in this thread?:
viewtopic.php?f=9&t=4986&p=21599#p21599
Doug Kightley
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net

User avatar
jimc
Posts: 1124
Joined: Wed Aug 28, 2013 11:02 pm
Location: mullica, nj
Contact: Website

Re: "holes" on Z axis -sketchup

Thu Apr 07, 2016 7:06 am

Your printing a little too hot. Lower the temp 5 deg at a time until it goes away. You may also need another 1 or 2 top layers

KC_703
Posts: 238
Joined: Tue Aug 26, 2014 5:23 pm

Re: "holes" on Z axis -sketchup

Sun Apr 10, 2016 1:55 am

Are you checking to make sure the object is manifold? Install the "Solid Inspector" plugin. "Clean Up" is another helpful plugin to remove stray lines that create problems for printed objects.

ARTISAN
Posts: 13
Joined: Wed Mar 30, 2016 8:17 pm

Re: "holes" on Z axis -sketchup

Sun Apr 10, 2016 4:44 am

dkightley wrote:Are you suffering from the issue I explained in this thread?:
viewtopic.php?f=9&t=4986&p=21599#p21599
no....its not deleading all of the overlaping part just the mashes/plains that "tuch" each other
but good info any way.!!
thanks

Return to “General Discussion and Tips”