Page 1 of 1

USB control of Rostock Max?

Posted: Mon Dec 09, 2013 12:36 pm
by JMP
I tried to do USB control of my Rostock Max with the new 2.0 software and was not able to do so (I had not tried with previous versions). Does anyone know if the Max is one of the supported printers for this function? I am using the repitier firmware from seemecnc version .83. I'm hoping it does since the Creator has a much nicer interface than the mac version of rep-host.

Re: USB control of Rostock Max?

Posted: Sun Dec 15, 2013 8:48 pm
by JMP
I emailed support. The issue was I was using a mac and it has issues with the default RMax baud rate. Adjusted it to 115200 on the bot and it work just great now.