Page 1 of 1

Dual Extrusion Wiper Walls

Posted: Wed Dec 25, 2013 12:33 pm
by davedfx
Is there a way to generate wiper walls for dual extrusion like Makerware? Printing dual without walls will have the second extruder contaminate the print. I have a flashforge dual and the second extruder will ooze even when it's not printing.
If not are there workarounds to minimise the problems?

Re: Dual Extrusion Wiper Walls

Posted: Fri Dec 27, 2013 5:09 pm
by Outbound
Same problem with Leapfrog Creatr (among many other problems).

Re: Dual Extrusion Wiper Walls

Posted: Mon Jan 27, 2014 12:12 am
by tobyCwood
davedfx wrote:Is there a way to generate wiper walls for dual extrusion like Makerware? Printing dual without walls will have the second extruder contaminate the print. I have a flashforge dual and the second extruder will ooze even when it's not printing.
If not are there workarounds to minimise the problems?
Can't you design in your own in each of the 2 merged models?

Re: Dual Extrusion Wiper Walls

Posted: Thu Feb 13, 2014 5:54 am
by deeeep
Would be nice if you could auto generate wiper walls in simplify... More or less like you auto generate brims and rafts.