This is the structure they sent me.
The actual retraction portion needed to be un-commented for the type of extrusion that my G-Code was using. I found out which type my profile used, by opening the G-Code tab and seeing if "Relative Extrusion Distances" was checked or not.
Code: Select all
; ***** pre-retraction code ***** ; ***** IF using relative extrusion distances ***** ; G1 E-[retract_distance] F[retract_speed] ; ***** IF using absolute extrusion distances ***** ; M83 ; set extrusion to relative coordinates ; G1 E-[retract_distance] F[retract_speed] ; M82 ; set extrusion to absolute coordinates again ; ***** post-retraction code *****
I hope this can help someone else. It was perfect for what I was doing.