Ooze shield

[Patrickp]

Hi all, how do I get s3d to retract when it finishes the Ooze shield ? I have retraction on, for both extruders and in the and in the advance tab I set checked and set the minimum travel to retract too 1mm with Ooze shield 3 mm offset yet it not retracting coming off the ooze shield and its depositing plastic on sides of my prints. Thanks

[dorsai3d]

Uncheck the option "Only retract when crossing open spaces" and it will retract there. It will also retract every time the head makes a non-printing move, but that's the only way to make that work at the moment.

Add your voice here perhaps? viewtopic.php?f=9&t=5018