Only just purchased Simplify 3D and cannot believe the change in bed adhesion and print quality with one unfortunate exception.
ANYTHING I print with support`s leaves massive scarring / pooling / burning of the object surface, pretty much turns an otherwise perfect print into scrap.
Its quite possibly something in my settings, but as only had the product 24 Hrs, thought some of you may be able to help eliminate this issue in minutes instead of hours / days and save me some mega frustrations - So close to a perfect print yet so far
Using 2 Flashforge printers, a Creator X and a Creator Pro, with both giving same result, never had scarring when using RepG, Slic3r.
Apart from that am truly impressed with software capabilities and the improved quality on my prints.