Posts: 1
Joined: Thu Feb 13, 2014 12:26 pm


Thu Feb 13, 2014 12:31 pm

Hello all first off Great software I have been using the daylights out of it and have only had it about 24 hours.

I believe my question is a simple one. Does s3d not accept g92 codes being sent prior to print start commands?

If not please consider this an wish for feature.

I print on many different printers throughout the day and like to g92 them to start at the center of the build platform.
Thanks again for the awesome software well worth the money.

Posts: 1436
Joined: Sun Feb 16, 2014 10:52 am

Re: g92

Sun Feb 16, 2014 4:48 pm

I've used G92 commands with it before. It works fine. But of course, if you have a G28 (home all axes) at the start of your build, that will override whatever you do with the G92. Anytime the hardware endstops are triggered, it automatically resets the current position to zero.

Return to “General Discussion and Tips”