Thomllama
Posts: 1
Joined: Tue Feb 07, 2017 8:03 am

infill not infilling..

Tue Feb 07, 2017 8:08 am

OK, I have a screen shot of the issue. I'm hoping it's just a setting but it always seems like S3D leave blank areas. this isn't a "it's too small" thing, or I need to up extrusion.. this is very obviously a black area that should be filled. any ideas? I've played with "thin wall behavior" and even went to extreme settings to no avail. something else I'm missing?

thanks
Thomas
Attachments
Screen Shot 2017-02-07 at 7.58.23 AM.png

User avatar
kabali16
Posts: 159
Joined: Thu Jan 28, 2016 1:10 pm
Location: 4th Dimension

Re: infill not infilling..

Wed Feb 08, 2017 12:59 pm

Long shot, but is the coasting turned ON ? places where coasting happens typically are shown blank in the preview.
Kabali daww!!
Prusa i3 | Kossel
Simplify3D | Cura | Repetier Host | Octoprint

Return to “General Discussion and Tips”