I have been using these settings, but i would love to see some known better settings !
Dose anyone use the Black Monoprice PETG, and can advise?
Right now I am just guess and checking based on very little understanding, there is not a lot out there that is specifically targeted for PETG on S3D afaict ?
Personally, I have increased retraction distance to 2.0mm
Reduced the Retraction Vertical Lift to 0.2mm
Increased to 2 skirt outlines because material really likes to ooze, and empty the extrusion cavity.
*** Is there any good settings for "End of Print filament retraction" , an subsequent "Start of Print Fillamaent Prime" simply to help mitigate the not printing oozing issue?